Wheeler Indiana Concrete Equipment Pads for Generators

A generator beside a Wheeler house needs a concrete pad under it. Soil that freezes will tilt the unit if it sits on bare ground. So we pour Concrete Equipment Pads in Wheeler for that job. People check after a winter, when the housing has shifted and the line looks tight. We hear about units that used to sit flat and now rock if you lean on them.

Wheeler, Indiana sees frozen ground in winter. Because the unit often sits out in the yard, it rests on soil away from the foundation. After a freeze and a thaw, a plastic pad or a stack of blocks can drop on one corner. Then the cabinet leans. We’ve pulled those thin pads up and found the stone washed out along one edge.

When a condenser starts to hum louder, people call us about it. Then the same call comes in when a generator rocks on its feet. We find a sound cabinet sitting on a pad that has dropped. A gap under one corner means the fan or the engine is out of level. We look at that gap before we talk about a new pour.

Cabe’s Concrete is a family owned and operated company. We’ve poured pads like these since our doors opened back in 2006. You can read how the crew works on our About Us page. We write each quote out line by line. We do not inflate the price of material to make a few extra dollars. The sheet lists the pad size and the hours we put on the job.

Base Work for Concrete Equipment Pads in Wheeler

The pad should run a bit larger than the unit footprint. After that, we dig out the soft topsoil. Then we place compacted stone so the concrete doesn’t sit in mud. That stone base is what keeps the unit from tilting when the soil under a Wheeler yard freezes. For a condenser, the pour is a short square set beside the house. For a generator, we match the cabinet the homeowner already owns. Then we leave the clearance the installer asked for.

Concrete Equipment Pads in Wheeler also have to send water away from the house wall. When the top falls back toward the siding, meltwater sits there. So we pitch the surface out toward the yard. After the pour, we keep people off it until the concrete can carry the unit.

Concrete Equipment Pads in Wheeler on Pour Day

We form the edges tight, because a small pad shows every bow. Then we pour and strike the top with a straightedge. So a light broom gives the tech some grip when they set the frame. Our crews run that straightedge again before we pull the forms.

We’ve set Concrete Equipment Pads in Wheeler for side-yard condensers. We’ve also set them for standby units out by a pole barn. The barn jobs sit in more open ground. So the stone base has to stay firm where mowers cross the corner. When we’re already there, people often ask about a service walk. Some ask about a garage floor that needs a tear-out and a new pour. That residential work can go in on the same visit if the day allows.

If the old pad is cracked through, we tear it out first. We do the same when it has sunk on one side. Pulling the old concrete out on a pad this size is a short job. But it has to come out clean so the new base sits on firm ground. We haul the broken pieces off with the rest of the spoil.

You can look through finished slabs in our photo gallery. Concrete Equipment Pads in Wheeler are on the same list as walks and floors. The details live on our concrete equipment pads work page.

Gas piping and the electrical hookup stay with the generator installer. Our pour is the concrete under the cabinet. After the unit is down, keep mulch and soil off the pad edge. That cover holds water against the concrete and can soften the base.