Schererville Indiana Concrete Curbs – How Plows Nick
Plow blades nick Concrete Curbs in Schererville when the steel rides the gutter and catches the face. Salt then sits in those chips, and the broken edge moves back a little more each winter. So if you walked the curb after the last melt and saw pale chips, that’s the usual cause.
Subdivision streets in town use curb and gutter. The curb holds the pavement edge and sends water toward the inlet. When a plow clears the street before the morning drive, the blade stays low. After that pass, the top corner and the face above the gutter take the hit. Driveway returns catch it too, because the curb height changes and the blade can jump.
People have called us in spring about a chunk gone at the apron. Others have called about a long scrape where the face used to sit square. We’ve pulled up short runs after a plow nick left the curb loose in the gutter. Once the edge is gone, the asphalt beside it starts to break up.
Concrete Curbs in Schererville, Indiana on a Straight Line

A sound run of Concrete Curbs in Schererville has a square face. The gutter pan stays tied to that face. The reveal stays even from one driveway to the next. When you look down the street, the top of the curb should look straight.
After a hard winter, look first at the driveway return, where the curb drops for the apron. Then look along any stretch where the plow had to hug the gutter. For example, a shallow nick will hold meltwater. Because that water freezes overnight, the chip grows. We’ve seen that on curb-and-gutter streets after salt season.
Get A FREE Proposal Today!
Salt Wear on Concrete Curbs in Schererville, Indiana

Town plows spread salt, and homeowners salt the apron as well. Salt sits in a chipped face and keeps that concrete damp through freeze and thaw. Then the surface scales. We’ve seen that scaling on Concrete Curbs in Schererville after a salted winter. We’ve found a soft, sandy edge and a crack running back from the nick.
A skim of mortar on that face rarely holds. The next plow takes the skim off, because the scaled concrete under it is already weak. So the lasting repair is a cut-out of the bad run and a new pour. We match the new curb height to the curb on each side.
Replacing Concrete Curbs in Schererville, Indiana

We saw-cut the bad section and pull the broken concrete. Then we set forms to the existing line and pour. We strike the face and tool the joints so the new run meets the old curb without a lip. We make that cut square so the new face lines up with the old one. On Concrete Curbs in Schererville, a short run is enough when the base under the gutter is still firm.
When the base has washed out, we dig that out and put stone back before the pour. The same visit can cover a broken service walk behind the curb. It can also cover a tear-out and replace at the driveway apron, if that slab failed with the curb.
You can see finished curb lines in our photo gallery. Cabe’s Concrete is a family owned and operated company. The About Us page covers our work since 2006. When the face is gone, our concrete curbs work is the cut-out and the new pour.
We write the quote out line by line. So you can see the curb length and the tear-out as separate lines. We source a mix we trust for a clean finish. Then we stay until the forms come off and the top edge is straight.
On a Schererville subdivision street, we match the new face to the curb that is still sound. The new curb sits at the pavement edge. So the forms have to hold a straight line while the concrete sets. We check that line against the old curb while we can still move the forms.