Calumet City Illinois Concrete Equipment Pads – Level
The practical choice is whether to shim a tilted condenser or replace the pad under it. After a hard winter in Calumet City, Illinois, that pad often sits out of level and the cabinet rocks. So you can stack plastic shims and wait, or you can have us pour Concrete Equipment Pads in Calumet City before cooling season starts. We hear about a pulled line set once the ground has thawed.
A lot of the units we look at sit on a thin precast pad. Some sit on a small square poured years back. Because that pad is only a few inches thick, it rides up when the soil freezes. Then one corner drops on the thaw. The condenser leans toward the house or out into the yard. People also call when a generator pad has done the same thing beside the garage.
Calumet City sits on lake-plain clay. That clay holds water close to the surface. When the clay freezes, frost heave lifts the pad that rests on it. A deep frost line in this part of Illinois reaches below a thin pad, so the pad is in the soil that moves. After the ice leaves, the clay settles unevenly. We have pulled up slabs that came out tipped, with a void under one edge. The condenser stayed bolted on.
What a Level Pour Does for Concrete Equipment Pads in Calumet City

We dig out the failed pad and the soft clay under it. Then we set a compacted stone base that drains. That base keeps water from sitting under the new pour. For a condenser or a standby generator, we pour thicker than the thin square we just removed. We size the pad so the unit’s feet land fully on concrete. When the forms come off, we check the top with a level before the equipment goes back.
We are a family owned and operated company, and we have done this work since 2006. You can see how the crew works on our About Us page. But the pad job itself is regular site work. We also do concrete removal and a tear out and replace when the walk beside the unit has heaved. Concrete Equipment Pads in Calumet City are part of the residential concrete we pour once the ground is open. The unit has to come off for the pour.
Get A FREE Proposal Today!
Concrete Equipment Pads in Calumet City When the Old Pad Comes Out

On a replacement we shut the unit down with the homeowner. Then we unbolt it and move it clear of the pad. After that we break out the old concrete and haul it off. So the new pour goes on a clean, drained base. We have found old pads with no stone under them at all. Someone cast those pads on bare ground, and they tip after a freeze.
The new pad gets a stone base and wood forms. Then we pour and screed the top flat. Because the condenser has to sit level, we do not slope the pad to shed water. We grade the soil so water moves off the stone and away from the foundation. On some jobs we also replace a short service walk if frost has lifted that slab. Our concrete equipment pad work covers this pour, plus residential concrete and concrete replacement.
A generator needs a pad that stays put so the cabinet stays in plane. When we set the new pad, we keep the top level. We check it before the equipment goes back on. Finished pads from jobs like these are in the Photo Gallery. Shims can stop the rocking for a while. After the next freeze they often need stacking again, and the line set moves with the cabinet each time.
So we use a poured pad on a drained base once the clay has moved a thin pad. In Calumet City that ground is the lake-plain clay under a lot of side yards. We have seen the same lean come back when someone only reset the old pad on the same soil. The unit’s feet need full bearing on the concrete. The line set needs the cabinet to stay put.