Munster Indiana Concrete Curbs – How
The plow hits that face of the curb on a tight pass. After a winter of road salt, the concrete behind the chip starts to scale. On these flat streets, Concrete Curbs in Munster have to hold the gutter line through that wear. So stormwater still has a path to the inlet.
A curb and gutter is a concrete edge with a flat pan at the street. The pan is the gutter. When the street is nearly level, that pan moves water toward the inlet. The crown of the road can’t carry it alone on a grade this flat. We’ve seen pans that cracked and dropped a little. Then water sat in the joint. You get a dark streak along the curb and a soft spot at the lawn edge once it thaws.
Concrete Curbs in Munster After Plow and Salt Wear

The blade chips the top edge and the street face. Salt brine sits in those chips. Because the brine melts snow and then refreezes overnight, the face goes through extra freeze cycles. We’ve pulled pieces where the paste had flaked off and the stone was bare. For example, a tap on the face will tell you if the concrete under the scale is loose.
Salt brine also gets into the joint where the gutter meets the asphalt. When that joint opens, the plow catches the lip on the next pass. So a small chip turns into a longer break along the run. People have called us after the gutter at a driveway apron broke back into the approach. But the same break shows up mid-block too.
Get A FREE Proposal Today!
Lake-effect snow off Lake Michigan can hit these streets in Munster, Indiana in a short heavy burst. Then plow trucks make extra passes and spread more salt. The gutter pan often fails first after that kind of winter. Because the grade is flat, water sits in a low pan and stops short of the inlet. We’ve replaced runs of Concrete Curbs in Munster where a settled pan missed the inlet. When that happens, stormwater leaves the pavement and ponds at the lawn edge.
That’s the spot that needs a new pour. A skim coat on the face will fail if the pan under it has cracked through. So we tear out the bad section and pour a new curb and gutter to the old flow line. The work usually means concrete removal and a tear out and replace of the broken run. We also cut the asphalt back so the new gutter has a clean joint. When the apron or a service walk has broken with the curb, we take that concrete out in the same visit.
How We Pour a New Section of Concrete Curbs in Munster

We set forms to the height of the sound curb still in place. And we check the gutter slope toward the inlet before we pour. We place the concrete and tool the face next. We cut the joints so they line up with the old run. After the pour, we keep wheels off the new curb until it can take a load. Cabe’s Concrete is a family owned and operated company, and we’ve been at this since 2006. You can read how the crew works on our About Us page.
Some streets only need the section at the driveway. When the plow drops into the apron, it catches the curb return. So a job for Concrete Curbs in Munster might be a short section at one driveway. A failed pan farther down the block takes a longer repair. Residential concrete at the approach often goes with it. We went to full concrete removal when the pan was gone. Our concrete curb and gutter work covers that range.
We source concrete we trust for exterior flatwork. And we don’t inflate the price of material to make a few extra dollars. Because we write the quote out line by line, hours and material show as separate lines. Photos of similar pours are in the Photo Gallery. Finished Concrete Curbs in Munster sit flush with the asphalt so water stays in the gutter.